Musiclily Pro 18mm ペグブッシュ オープンスタイル エレキベースのチューニングペグマシンヘッド用 ブラック(4個セット)

I bought these to replace bushings that were missing on a Bass I was repairing for someone who installed Schaller's in the 80s. The inside diameter was just a bit too tight to slide over the tuner shaft, I had to ream out all four of them so they could clear. It didn't take much but it had to be done. Keep this in mind in case you don't have the tools to do that. Otherwise very good quality for the price.

The media could not be loaded.

These work perfect for my squier Jazz Bass. I've got the cv70 and I've replaced the machine heads with Guyker machine heads as they are the closest in physical size to the original hardware. The machine heads come with an extremely small washer which barely covers the remaining hole after the machine head has been attached through the head of your bass. Many people have complained about this but I took a different route and purchased these grommets and then reamed out the hole on the inside so that they could be used for said machine heads. Using an aluminum dowel wrapped with 150 grit sandpaper I was able to bore the hole larger by over a millimeter which was enough for them to work perfectly! Once the fit was achieved they installed no differently than a factory set of Fender machine heads. The material that these grommets are made out of was non-magnetic. Seemed like aluminum alloy of some sort.

These bushing are made to fit 18mm peg hole size made in china bass guitar necks tuning holes only.

These bushings are sized perfectly for the bass guitar I am working on. Thank you Musiclily for such fine products.

Perfect fit